Table of Contents
Advertisement
Use an SAE multipurpose high temperature grease with extreme pressure (EP)
performance. Also acceptable is an SAE multipurpose lithium-based grease.
• Use a Maintenance Checklist to keep record of all scheduled maintenance.
• Use a hand-held grease gun for all greasing.
• Wipe grease fitting with a clean cloth before greasing to avoid injecting dirt and grit.
• Replace and repair broken fittings immediately.
If fittings will not take grease, remove and clean thoroughly.
NOTICE
Also clean lubricant passageway. Replace fitting if necessary.
Si les raccords ne prendront pas la graisse, enlever et nettoyer.
AVIS
Aussi propre passage de lubrifiant. Remplacer approprié si
nécessaire .
1. Check the conveyor belt tension and alignment.
2. Grease conveyor bearings.
A. Two bolt flanged bearings, tail roller bearings right and left (2 locations).
B. Two bolt flanged bearings, drive roller bearings right and left (2 locations).
3. Wipe down the motor casing with a damp cloth making sure to remove all dust
that may have collected since the last maintenance date. Record the cleaning on
the company required documents. If operating in a CSA 22.1, Class II, Division 2,
Group G hazardous area, USC recommends this step be performed on a daily
basis.
•
Essuyez le carter moteur avec un chiffon humide en veillant à éliminer toutes
les poussières qui peuvent avoir perçu depuis la dernière date de maintenance.
Enregistrez le nettoyage sur la société les documents requis. Si opérant dans
un CSA 22.1, Classe II, Division 2, Groupe G zone dangereuse, USC recommande
cette étape être effectuée sur une base quotidienne.
LPV WEIGH BELT SEED TREATER
GREASING
WEIGH BELT SERVICING INTERVALS
Every 40 hours or Weekly
Page 45
Advertisement
Table of Contents
