Section F; Maintenance - USC LPV Operator's Manual

Proper maintenance of the LPV Weigh Belt Seed Treater is critical for peak
performance, reliability and accuracy of this system. The following is a guideline
for the type of maintenance and servicing that should be performed on this unit.
Your environment and uses may require additional maintenance and service beyond
this list to assure a reliable and safe unit. The operator of this unit has ultimate
responsibility to identify areas of concern and rectify them before they become
a hazard or safety issue. There is no substitute for a trained, alert operator.
! DANGER
! DANGER
! AVERTISSEMENT
LPV WEIGH BELT SEED TREATER

Maintenance

Do not put this unit into operation with any questionably
maintained parts. Poor performance or a hazard may occur.
Ne mettez pas cet appareil en service avec une pièce inutilisable.
Une mauvaise performance ou un danger peut survenir.
Do not use compressed air or water under pressure to clean any
of the components of the USC equipment.
Ne pas utiliser d'air comprimé ou de l'eau sous pression pour
nettoyer l'un des composants de l'équipement USC.
Failure to maintain the proper belt tension will cause the
belt to slip. This will damage the belt and head drive pully.
If the belt is not tracking correctly, it can ride along one
edge causing the belt to fray on the sides. Either problem
will cause the belt to burn or wear out prematurely.
Défaut de maintenir la tension de la courroie provoquera la
courroie de glisser. Cela pourrait endommager la courroie
et la tête d'entraînement pully. Si la courroie ne suit pas
correctement, il peut rouler le long d'un bord causant la
courroie effilocher sur les côtés. Soit problème provoquera
la ceinture de brûler ou d'usure prématurée.
Section
F
Page 43