Section B; Installation - USC LPV Operator's Manual

Installation

Section
B
! DANGER
! DANGER
NOTICE
AVIS
USC equipment may operate within a Group II, Division 2, Class G hazardous area
which contains seed dust. If so, the equipment must be certified for use in this area.
To avoid the possibility of an explosion ignited by static electricity, all USC equipment
should be grounded by attaching a bonding strip to the metal frame and securing that
strip to the factory ground point.
If labeled accordingly, USC products are designed to comply with CSA 22.1 for use
in a Class II, Division 2, Group G environment. When connecting the USC system
power cord into a power supply, first determine if the supply is also within the
hazardous area where the USC system is located. If so, we recommend that the
power be hard wired into the source. Do not use a standard electrical plug for this
purpose. For other acceptable methods of connecting to a power source, or any other
additional miscellaneous equipment to the USC system within a hazardous location,
please consult CSA 22.1, Section 18-200 and 18-274. Review the appropriate section
and ensure compliance with one of the options given.
When connecting to USC equipment from a remote location, and the USC equipment
is in a hazardous Class II, Group G environment, customers are advised to follow the
requirements within CSA 22.2 no. 25. More details may also be found in CSA 22.1
18-252 (wiring methods). There are various options covered within this section for
wiring in a Class II, Group G (dust) environment. Select the best method suited for
your specific location.
LPV WEIGH BELT SEED TREATER
Installation
HIGH VOLTAGE ~ Always disconnect the power source
before working on or near the control panel or lead wires.
HAUTE TENSION ~ Toujours débrancher la source
d'alimentation avant de travailler sur ou près du panneau de
commande ou les câbles.
HIGH VOLTAGE ~ Use insulated tools when making
adjustments while the controls are under power.
HAUTE TENSION ~ Utilisez des outils isolés lors des réglages,
tandis que les commandes sont sous tension.
Permanent installation may require additional electrical cords,
chemical tubing, and air lines, since each installation is unique.
Installation permanente peut exiger cordons électriques, des
tubes supplémentaires chimique, et les conduites d'air, puisque
chaque installation est.
Section
B
Page 19