Appendix E Suggestion Of Mechanical Lidar Mount - RoboSense RS-Ruby User Manual

RS-Ruby Users' Manual

Appendix E Suggestion of Mechanical LiDAR Mount

Please make sure the surface of platform used for mounting LiDAR is smooth as possible.
Please make sure the locating pin on the mount surface do exceed 4mm high.
The material of the mount platform is suggested to be aluminum alloy in order to
thermolysis.
When the LiDAR is installed, if there is a mounting contact surface on the upper and
bottom sides of the LiDAR, make sure that the spacing between the mounting surfaces is
greater than the height of the LiDAR to avoid squeezing the LiDAR.
Please don't mount the LiDAR in a tilt position where the tilt angle exceeds 90 degrees,
this will reduce the sensor life time.
When the LiDAR cable is routed in the mount device, please keep the cable a little slack,
not too tense.
34