Nidec Answer Drives 700E Installation & Operating Instructions Manual page 4

AD700E
Summary
Chapter 1
P. 5
General information
Chapter 2
P. 7
Important safety information
Chapter 3
P. 12
General Information and Ratings
Chapter 4
P. 15
Mechanical Installation
Chapter 5
P. 21
Power Wiring
Chapter 6
P. 29
Operation
Chapter 7
P. 31
Parameters
Chapter 8
P. 42
Analog and Digital Input Macro
Configurations
Chapter 9
P. 48
Modbus RTU Communications
Chapter 10
P. 50
Technical Data
Chapter 11
P. 54
Trouble Shooting
1 General information 1.1 Electromagnetic Compatibility
2 Important Safety Information 2.1 Quick Start Up
2.2 Quick Start Process
3 General Information and Ratings 3.1 Identifying the Drive by Model Number
4 Mechanical Installation 4.3 Mechanical Dimensions and Mounting –
4.1 General
4.2 UL Compliant Installation 4.4 Guidelines for Enclosure Mounting –
5 Power Wiring 5.5
5.1 Grounding the Drive 5.6
5.2 EMC Filter Disconnect 5.7
5.3 Wiring Precautions 5.7.1 Internal Thermal Overload Protection
5.4 Incoming Power Connection 5.7.2 Motor Thermistor Connection
6 Operation 6.2 Changing Parameters
6.1 Managing the Keypad 6.3 Read only parameter access
7 Parameters 7.1 Standard Parameters
7.2 Extended Parameters
8 Analog and Digital Input Macro 8.3 Macro Functions – Terminal Mode
Configurations
8.1 Overview 8.4 Macro Functions - Keypad Mode
8.2 Macro Functions Guide Key
9 Modbus RTU Communications 9.2 Modbus RTU Specification
9.1 Introduction 9.3 RJ45 Connector Configuration
10 Technical Data 10.1 Environmental
11 Trouble Shooting 11.1 Fault Code Messages
Quick Start – IP20 & IP66 Non Switched
Quick Start – IP66 Switched
3.2 Drive Model Numbers
4.5 Mechanical Dimensions – IP66 (Nema 4X)
IP20 Open Units Enclosed Units
4.6 Guidelines for mounting (IP66 Units)
IP20 Units
Drive and Motor Connection 5.8 Control Terminal Wiring
Motor Terminal Box Connections 5.9 Connection Diagram
Motor Thermal overload Protection 5.9.1 IP66 (Nema 4X) Switched Units
5.9.2 IP20 & IP66 (Nema 4X)
Non- Switched Units
6.4 Resetting parameters
6.5 Resetting a fault
7.3 Advanced Parameters
7.4 P-00 Read Only Status Parameters
8.5 Macro Functions - Fieldbus Control Mode
(P-12 = 0) (P-12 = 3, 4, 7, 8 or 9)
8.6 Macro Functions - User PI Control Mode
(P-12 = 1 or 2) (P-12 = 5 or 6)
9.4 Modbus Telegram Structure
9.5 Modbus Register Map
10.2 Rating Tables
4.7 Gland Plate and Lock Off
4.8 Removing the Terminal Cover
4.9 Routine Maintenance
5.10 Using the REV/0/FWD Selector Switch
(Switched Version Only)
5.11 Control Terminal Connections
8.7 Fire Mode
8.8 Example Connection Diagrams
10.3 Additional Information for UL Compliance
4