Advertisement
7.
Attach the address jumper in the position shown to the additional disk
drive to be installed:
Note:
Only disk drives in odd-numbered slots (1 3 5 7 ) have an
address jumper.
PICTURE 391
8.
Insert the disk drive assembly into the unit.
PICTURE 392
9.
Attach the following cables:
a.
Disk drive data cable
b.
Disk drive power cable
PICTURE 393
10. Enter n
PICTURE 394 on the control panel where n is the slot number
of the disk drive that was just installed.
Notes:
a.
The control panel displays a disk drive status with the up arrow
( ) in the position of the added disk drive and a solid block
( ¦ ) in the position of the next disk drive to be added.
example, the following illustration shows that you just installed
a disk drive in slot 7 and the next slot available is slot 2.
+-----------------+
¦ 1 ¦ 3
5
+-----------------+
1 2 3 4 5 6 7 8
b.
If you get an error, see "Control Panel Command Return Code
Information" in topic 3.4 for a description of the error.
Example:
+-----------------+
¦ 3 0 2 9
E 6
+-----------------+
1 2 3 4 5 6 7 8
c.
A return code of DE may indicate an address jumper or cable is
incorrectly installed.
11. Do you want to install another additional disk drive?
No
Yes
Return to step 5 and repeat these steps for each additional disk
drive that needs to be installed.
12. Attach the front EMC shield.
Note:
Engage each thumbscrew before you tighten either screw.
PICTURE 395
13. Restore the control panel to operating position and tighten screw
PICTURE 396
3514 Service Information
Installing Additional Disk Drive Features
1 .
2 .
¦
¦
This command cannot be
performed.
This drive
is not present or not
in the configuration
record.
¦ Copyright IBM Corp. 1992, 1993
5.1 - 2
For
1 .
Advertisement
