Advertisement
PICTURE 347
22. Remove the screws securing the connector panel to the enclosure.
a.
Six screws
1
b.
Two screws
2
Then, remove the connector panel.
Note:
The end of the connector panel with the control panel cable
must be pivoted out first.
PICTURE 348
23. Remove the fans from the connector panel.
Note:
Use a screw driver to pry loose the spring clip that holds the
fan to the connector panel.
PICTURE 349
24. Attach the fans to the replacement connector panel using the clips
removed in step 23.
25. Insert the replacement connector panel.
Notes:
a.
Insert the control panel cable toward the front.
b.
Ensure that the adapter cable is to the rear.
c.
Firmly seat the connector panel seats into the guide flange on the
side of the 3514 frame.
26. Attach the connector panel and screws to secure the connector panel to
the disk enclosure.
a.
Two screws
2
b.
Six screws
1
PICTURE 350
27. Attach the two cable connectors to the enclosure.
PICTURE 351
28. Connect both fan power cable connectors.
PICTURE 352
29. Install the mounting plates using the screws and holding each mounting
plate to the 3514 enclosure.
Connect the line filter power cord to the connector panel.
PICTURE 353
30. Attach the side covers.
31. Attach the top cover.
32. Install all power modules using the screws removed in step 16.
33. Attach the rear EMC shield.
3514 Service Information
Connector Panel
outside the enclosure.
inside the enclosure.
inside the enclosure.
outside the enclosure.
¦ Copyright IBM Corp. 1992, 1993
4.5.11 - 3
Advertisement
