Download Print this page

IBM PS/2 3514 Service Information page 104

Advertisement

PICTURE 107
11. Can all the disk drives recorded in step 4 be found?
Note:
Check each disk drive serial number (printed on a label on top
of the disk drive).
PICTURE 108
No
Yes
Go to step 18.
12. Can all the disk drives recorded in 4 except one be found?
Yes
No
Go to step 24.
13. Insert each disk drive, except the one which could not be found, in
the slot recorded in step 4.
Attach the disk drive power and data cables.
Warning:
If these disk drives have been installed in another device
or system, data corruption may be present.
any doubt concerning the data integrity of the disk drives.
Note:
Ensure that each disk drive is connected to the correct power
cable and signal cable. Also, ensure that the address jumper is
installed in the position shown and is only installed on disk drives
in odd-numbered slots (1, 3, 5, or 7).
PICTURE 109
14. Insert a new disk drive in the slot for which the disk drive could not
be found.
Attach the disk drive power and data cables.
15. Set the Power switch to the On position.
16. After 3 minutes, a URC should be displayed on the 3514 control panel?
Is 35147xx9 or 35148xx9 displayed on the 3514 control panel?
Yes
No
Go to "Starting Problem Analysis" in topic 1.2.
17. Install the new disk drive.
with the slot number of the new disk drive.
This will make the new disk drive part of the 3514 configuration and
will rebuild the data on it.
End of procedure.
18. Set the Power switch to the Off position.
19. Insert each disk drive in the slot recorded in step 4.
Attach the disk drive power and data cables.
Warning:
If these disk drives have been installed in another device
or system, data corruption may be present.
any doubt concerning the data integrity of the disk drives.
Note:
Ensure that each disk drive is connected to the correct power
cable and signal cable. Also, ensure that the address jumper is
installed in the position shown and is only installed on disk drives
3514 Service Information
URC CE29
Go to step 24 if you have
Use "Reset Disk Drive" in topic 4.5.7
Go to step 24 if you have
¦ Copyright IBM Corp. 1992, 1993
3.5.6.1 - 2

Advertisement

loading