Advertisement
a.
9
PICTURE 139
Note:
This command can take up to 80 minutes to complete.
on this disk drive will be built again.
b.
As the command processes, the display indicates the percent
completed.
c.
When the operation ends without error, a quick status of the disk
drives is displayed.
Example:
+-----------------+
¦ 1 2 3 _ 5 _ 7 _ ¦
+-----------------+
1 2 3 4 5 6 7 8
d.
If the 3514 detects an error during the 4 2 9 n command, a return
code is displayed.
To determine if further action is required, go to "Control Panel
Command Return Code Information" in topic 3.4.
+-----------------+
¦
4 2 9 n
x x ¦
+-----------------+
1 2 3 4 5 6 7 8
Note:
A return code of DE may indicate an address jumper or cable
is not installed correctly.
e.
Press the * (Home) key to clear the display and return it to ready
status (*000).
Warning:
Do not continue with step 19 until the exchange is
complete.
19. Attach the front EMC shield.
Note:
Engage both thumbscrews before you tighten either screw.
PICTURE 140
20. Restore the control panel to operating position and tighten screw
PICTURE 141
21. Install the front cover (see "Front Cover Removal or Installation
Procedure" in topic 4.3).
22. The data on the 3514 must be recovered using the latest backup data
available.
See your system unit and operating system manuals for
instructions.
Do not attempt to save data from the failing 3514.
End of procedure.
3514 Service Information
URC 71pF 73pF 76pF 7FpF 81pF 83pF 86pF 8FpF
Indicates the disk
configuration
Return Code x x
on disk drive n.
¦ Copyright IBM Corp. 1992, 1993
3.5.12.1 - 3
Data
1 :
Advertisement
