Advertisement
1 2 3 4 5 6 7 8
22. Complete the Exchange Power Module command by entering the following
sequence on the control panel:
9
PICTURE 377
A power module quick status is displayed when the command is complete.
All power modules are operating correctly when the power module quick
status display shows:
+-----------------+
¦ A
B
C
¦ All Power modules
+-----------------+ are operating
1 2 3 4 5 6 7 8
If the 3514 detects an error during the 4 3 9 n command, a return code
is displayed.
To determine if further action is required, go to "Control Panel
Command Return Code Information" in topic 3.4.
+-----------------+
¦
4 3 9 n
x x ¦
+-----------------+
1 2 3 4 5 6 7 8
23. Press the * (Home) key to clear the display and return it to ready
status (*000).
24. Install the front cover (see "Front Cover Removal or Installation
Procedure" in topic 4.3).
End of verifying a repair.
25. Set the 3514 Power switch to the On position.
26. After 3 minutes, the power-up sequence should be complete.
Is *000, B000, or 3514xxxx displayed?
No
Yes
Go to step 29.
27. Is the code BBA0 displayed?
Yes
No
Go to "Starting Problem Analysis" in topic 1.2.
28. Wait until the display changes. This can take up to 30 minutes.
Is *000, B000, or 3514xxxx displayed?
Yes
No
Go to "Starting Problem Analysis" in topic 1.2.
29.
Note:
The failure has been corrected, but the error must now be
cleared using the Exchange Disk Drive command.
Using the control panel, enter the following sequence where n is the
location (1 through 8) of the disk drive that was exchanged or is
reporting an error.
4 2 9 n
PICTURE 378
The control panel displays a disk drive configuration with the slot
number of the drive to be reset indicated by a solid block.
Example:
+-----------------+
¦ 1 2 3 _ ¦ _ 7 _ ¦
+-----------------+
3514 Service Information
Verifying a Repair
correctly.
Return Code x x
on disk drive n.
Indicates the disk
in slot 5 is to
¦ Copyright IBM Corp. 1992, 1993
4.5.17 - 3
Advertisement
