Starting Up The Printer; Unpacking And Setup - Phoenix Contact THERMOMARK CARD 2.0 User Manual

THERMOMARK CARD 2.0
2

Starting up the printer

8 / 44
PHOENIX CONTACT
2.1

Unpacking and setup

Scope of supply
– Printer
– Mains cable
– USB cable
– THERMOMARK-RIBBON 110/50 ink ribbon
– Empty film core (possibly already mounted on the take-up hub)
– THERMOMARK CARD UCT-MAG 1 and THERMOMARK CARD US-MAG 1 maga-
zines
– UCT and US printing samples
– UCT-TM 6 and US-EMLP (85,6x54) materials
– Package of cotton buds for cleaning the printhead
– Data carrier with download link for the driver. The data carrier also contains this user
manual in several languages.
– User manual in German and English
Unpacking
• Check the device for damage which may have occurred during transport.
• Retain the original packaging for subsequent transport.
When transporting the printer, you must remove the ink ribbon and the magazine.
Unlocking the transportation safeguard
Figure 2-1 Unlocking the transportation safeguard
• Move the slider to the
Requirements for the installation location
NOTE: Damage to the device
Only operate the device in locations that are dust-free as far as possible, dry and protect-
ed against splashwater. Protect the device and materials from humidity, damp, and dirt.
Do not expose the device to direct sunlight.
• Place the device on a level surface.
position.
108770_en_01