Starting A Print Job; Inserting The Material - Phoenix Contact THERMOMARK CARD 2.0 User Manual

UCT...
The square markings in the corners of
the magazine and the material must
line up.
108770_en_01
2.4.3

Starting a print job

• Before switching on the printer, unlock the transportation safeguard (see
transportation safeguard"
• Start a print job. You can also start a test print via the display (see
page 23).
The material to be inserted appears on the display. Depending on the default setting,
the compartment is moved out automatically (see
job" on page 20).
• Move the compartment out, if necessary. To do this, touch the
play.
• Insert a magazine appropriate for the print job.
2.4.4

Inserting the material

NOTE: Damage to the printhead
Make sure that the material is not contaminated in any way. The material must be free of
grease, fingerprints, and dust, and it must be dry.
• Insert the material in the magazine. Note the orientation of the material.
UM...
There are two pins of different length on
the bottom of the UM material. The long
pin must be on the left-hand side.
• You can print UCT, UM or US material even if one or more full strips are missing from
the card. However, do not insert material with incomplete strips.
• Close the compartment using the
material.
If the material is inserted correctly, printing is started. Once printed, the compartment is
moved out again.
• Remove the material.
• Insert new material until the print job is complete.
• You can repeat the last printed page via the
on page 8).
"Compartment opens in case of print
US...
The material has two holes which fit
over the pins in the magazine. The
elongated hole must be on the left-
hand side.
button on the display. The printer checks the
button on the display.
Starting up the printer
"Unlocking the
"Test print" on
button on the dis-
17 / 44
PHOENIX CONTACT