Table of Contents
Advertisement
Modbus Server – DALI
TM
Intesis
Device type
Modbus Address
First Address is 0
7000 * line + (20 * gr) + 6414
7000 * line + (20 * gr) + 6415
2.4.3 Broadcast signals
Broadcast signals allow to control all ballasts in the same line from an individual signal. Their Modbus addresses can be obtained applying the following formula:
Where:
LINE NUMBER;
0..1 (always 0 if using version with support for 1 DALI channel)
SIGNAL NUMBER:
6800..6815, see following table
Modbus address from the formula is expressed in link layer format. This is, first register address is 0.
Supported signals vary according to device type. Following abbreviations are done in the table:
•
FL: Fluorescent light (device type 0)
•
EML: Emergency light (device type 1)
•
LED: LED module (device type 6)
© HMS Industrial Networks S.L.U - All rights reserved
This information is subject to change without notice
Ballast /
Read/
Register/signal name
Write
x
R/W
Burn-in time Status
x
R/W
Burn-in time
Modbus Address = 7000 x channel + SIGNAL NUMBER
Possible values
0-Stopped, 1-Running
0-Stop, 1-Start
User Manual r1.3 EN
URL
https://www.intesis.com
19 / 39
Advertisement
Table of Contents
