Alcatel-Lucent OmniPCX Office Manual page 61

when they are full. These three tables are returned to the GET request done by a supervisor.
The historic event and hardware anomaly tables allow reading the recent problems that have
occurred. Some of these problems correspond to the traps sent by OmniPCX Office, but most
of them only describe less important troubles that the system has encountered.
When an alarm reports the occurrence of a problem, and another one reports the end of the
same problem, then they are correlated. The following table is a synthetic view of correlated
alarms of the call handling MIB.
Alarm description
System reset
Cabinet alarm
Board alarm
Main power supply
failure
Fan alarm
ISDN T2 access
problem
VoIP board Ethernet
interface problem
IBS alarm
Access Mbx
Access Wsapi
10.3 Configuration
10.3.1 Configuring the SNMP Service
The SNMP configuration is performed using the OMC tool. The SNMP service can be
activated or deactivated via the OMC tool (deactivated by default).
Note:
In case of default, the access to the SNMP service is not enabled for the supervisor and all parameter
fields are empty.
To declare the SNMP Service to Supervisors:
1. From the OMC tool, navigate to the menu
2. Review/modify the following global parameters:
Enable Flag
System Contact
table 10.2: Call handling MIB
Start
ochmSystemRestart
ochmCabinetUnplugged
ochmBoardUnplugged
ochmBoardPermanentReset
ochmPowerSupplyFailure
ochmFanFailure
ochmIsdnFailure
ochmVoipLinkDown
ochmIbsSynchroDown
ochmRemoteAccessMbxLocked
ochmRemoteAccessWsapi-
Locked
Select the check box to activate the SNMP service
Enter contact information of the person responsible for this man-
aged system
Alarm
End
ochmSystemRestarted
ochmCabinetOperational
ochmBoardOperational
ochmPowerSupplyOperational
ochmFanOperational
ochmIsdnOperational
ochmVoipLinkUp
ochmIbsSynchroUp
ochmRemoteAccessMbxUnlocked
ochmRemoteAccessWsapiUnlocked
61/62