Alcatel-Lucent OmniPCX Office Manual page 35

Type Message
110 APPEARANCE OF A TERMIN-
AL
A terminal has been recognized
by the system. This terminal is
now operational
NB: this message will only be
sent if the NMC is present and
active
111 DEVICE REFUSED
Configuration limit attained
112 FAULT ON A DEVICE
113 INTERFACE REFUSED
An interface was refused be-
cause the system limits were
exceeded
120 CABINET OPERATIONAL
121 CABINET REFUSED
122 CABINET UNPLUGGED
123 MAIN FAILURE
Location Additional Information
Board loca- INFO 0 = type of terminal
tion. INFO 1 = reason for restarting
Interface
marker
Board loca- INFO 0 = type of device
tion. INFO 1 = cause of refusal
Interface INFO 2 = 1 (software license prob-
marker lem; in this case, INFO 1 = 255
(terminal not totally refused, be-
cause recognized by MMC)
Board loca- INFO 0 = type of device
tion. INFO 1 = type of error
Interface
marker
Board loca- INFO 0 =type of interface
tion. INFO 1 = cause of refusal
Interface
marker
Controller INFO 0 = type of backpanel board
board (81 (3 = wall mounted; 4 = RACK1U; 5
or 82) = RACK2U; 6 = RACK 3U; 7 =
RACK 1U G2; 8 = RACK 2U G2; 9
= RACK 3U G2; 10 = RACK XS; 11
= RACK XS-N
INFO 1 = module operating mode
(0 = restricted mode, running on
battery; 1 = normal mode, running
on the electrical power supply)
Controller INFO 0 = reason for rejection
board (81
or 82)
Controller
board (81
or 82)
CPU (80) INFO 0 = Main power supply state
(0 = Electrical power supply KO -
battery activated; 1 = Electrical
power supply OK; 2 = System on
battery, only with 2G power supply)
Action
Check the
hardware
configuration
(the system
limits may
have been ex-
ceeded).
If the fault re-
curs fre-
quently,
check the ter-
minal and its
connections.
Check the
hardware
configuration
(the system
limits may
have been ex-
ceeded).
35/62