Alcatel-Lucent OmniPCX Office Manual page 26

Chapter
6
Type Message
55 INTERNAL FAULT ON S0
Internal problem detected
on an S0 access following
release message giving
cause as "deactivation of
level 1"
58 ISDN BOARD FAULT
A level 1 error was detected
by the board's OBC
72 UNSUCCESSFUL AT-
TEMPT TO PRINT
Message sent by the output
device (printer) after every 5
failed print attempts.
103 OBC FAULT
200 4070 IO/EO BASE: SLAVE
LINK CONNECTED TO IN-
VALID INTERFACE
201 4070 IO/EO BASE: FRE-
QUENCY REJECTION
Discrepancy between the
number of frequencies con-
figured by the installer and
the number of DECT fre-
quencies processed
202 4070 IO/EO BASE: LOSS
OF SYNCHRONIZATION
ON UA LINK 0
203 4070 IO/EO BASE: LOSS
OF SYNCHRONIZATION
ON UA LINK 1
204 4070 IO/EO BASE: NO
REPLY ON DSP PRESENT
(RESET)
205 4070 IO/EO BASE: TRANS-
MISSION ERRORS DE-
TECTED ON SERIAL LINK
TO DSP (RESET)
26/62
Location Additional Information
Board location.
Access marker
Board location. INFO 0 = type of error (not significant) If the fault
Access marker
Board location. INFO 0 and 1 = type of fault
Board location. INFO 0 = interface number invalid
Interface mark- INFO 1 = base station operating status
er
Board location. INFO 0 to 3 = bitmap of frequencies
Interface mark- authorized and in use
er For more information, refer to the "In-
stalling 4070 IO/EO base stations", file
in the "Mobility" section.
Board location. INFO 0 = link status (0 = link KO; 1 =
Interface mark- link OK)
er
Board location. INFO 0 = link status (0 = link KO; 1 =
Interface mark- link OK)
er
Board location.
Interface mark-
er
Board location.
Interface mark-
er
Action
If the fault
keeps recur-
ring, check
the bus wir-
ing.
keeps recur-
ring, check
the bus wir-
ing.
Check the
printer and its
connection
cable.
Check the
cables on the
2nd link in the
base station
Check cabling
Replace the
4070 base
station
Check cabling
Replace the
4070 base
station