Epson SC-R5000 Series User Manual page 13

SC-R5000 Series/SC-R5000L Series User's Guide
A
Drive switch
Rewinds media during media replacement.
B
Media holder
Place media on these holders. There are same parts on both the left and the right.
C
Waste Ink Bottle
Waste ink collects in this bottle. There are two waste ink bottles; for color ink on the left and Optimizer (OP)
on the right.
Replace it with a new waste ink bottle when a message is displayed on the control panel prompting you to do so.
"Disposing of Waste Ink" on page 89
U
D
Level gauge
When installing on a carpeted floor or a sloping floor, check the horizontal level of the printer. There are same
parts on both the left and the right.
Regions other than North America and Latin America: U Setup Guide (booklet)
North American and Latin American users: Contact your dealer for product installation. The product must be
installed by an authorized dealer. Damage to the product from unauthorized installation will not be covered by
your Epson warranty.
E
Lift lever
If the media to be mounted on the media holder seems heavy, use these levers to raise the media to the level of
the media holder. There are same parts on both the left and the right.
F
Media support
Rest media on these supports before placing it on the media holder. There are same parts on both the left and
the right.
G
Casters
There are two casters on each leg. Once installation is complete, the casters should be kept locked while the
printer is in use.
H
Adjusters
There are two adjusters on each leg. When installing on a carpeted floor or a sloping floor, check level gauge of
the printer and adjust these to keep the printer stable. If you perform horizontal adjustment during
installation, make sure you raise the levelers above the casters before moving the printer.
"Moving the Printer" on page 133
U
I
Handle
After placing media on the right media holder, rotate the handle to press the media holder and apply pressure
to the roll core.
Introduction
13