Toshiba PORTEGE R400 Maintenance Manual page 272

4.20 Sensor board
4.20 Sensor board
Removing the Sensor board
The following describes the procedure for removing the sensor board. (See Figure 4-32.)
1. Remove the following screw.
• M2×3C
2. Remove the sensor board from the slot.
3. Disconnect the sensor cable from the connector CN9820 on the sensor board.
Sensor cable
CN9820
Sensor board
Installing the Sensor board
The following describes the procedure for installing the sensor board. (See Figure 4-32.)
1. Connect the sensor cable to the connector CN9820 on the sensor board.
2. Install the sensor board to the slot and secure it with the following screw.
• M2×3C
PORTÉGÉ R400 Maintenance Manual (960-623)
S-THIN HEAD screw
Figure 4-32 Removing the sensor board
S-THIN HEAD screw
4 Replacement Procedures
×1
M2x3C S-THIN HEAD
×1
[CONFIDENTIAL] 4-53