Table of Contents
Advertisement
Operating instructions
FSZ-M
4.2
Trouble shooting
Pos : 24.6 /07 Wartung und Pfl ege/02 Störungsbesei tigung/Störungsbes eitigung-mechan. @ 2\mod995_2.doc x @ 7235 @ @ 1
ERROR
The clamping-power is not big
enough, the load is slipping out
(optional)
(optional)
(Adjustment of the gripping range)
(optional)
(Property of material)
Unbalanced load
(Adjustment of the gripping range)
(optional)
Automatic release does not work
mechanical
(optional)
Pos : 24.7 /07 Wartung und Pfl ege/03 R eparatur en/Ü_R epar aturen @ 0 \mod24_2.doc x @ 7277 @ @ 1
4.3
Repairs
Pos : 24.8 /07 Wartung und Pfl ege/03 R eparatur en/Reparaturen @ 0\mod118_2.doc x @ 7291 @ @ 1
●
Only persons with the appropriate knowledge and ability are allowed to repair the device.
●
Before the device is used again, it has to be checked by an expert.
Pos : 24.9 /07 Wartung und Pfl ege/04 Prüfungspflic ht/Ü _Prüfungspflic ht @ 0\mod119_2.doc x @ 7095 @ @ 1
4.4
Safety procedures
It is the contructors responsibility to ensure that the device is checked by an expert in periods of
max. 1 year and all recognized errors are removed ( see BGR 500).
The corresponding legal regulations and the regulations of the declaration of conformity have to be
observed!
We recommend, that after checking the device the badge „Safety checked" is put on the device.
(Order-No.: 2904.0056+inspection sticker with date).
●
You can receive these badges from us.
14 / 15
Contents
CAUSE
The grippers are worn
The maximum load is exceed
The actual opening width is not
correct
The surface of the material is
dirty or the material is not
suitable / allowed for this device.
The device is not loaded
symmetrically
The adjustment of the gripping
range is not symmetrical.
Automatic release does not work
V3
REPAIR
Replace the grippers
Reduce the weight of. the load
Adjust the gripping range
according to the load you want to
transport
Check the surface of the material
or ask the manufacturer, if you
the material is allowed for this
device.
Adjust the position of the load
Correct the adjustment of the
gripping range
Clean automatic release with high
pressure-cleaner
Oil the automatic release (never
with grease)
Change the inset of the
automatic release
DE
Advertisement
Table of Contents
