Table of Contents
Advertisement
Operating instructions
FSZ-M
Pos : 19 /06 Bedi enung/06 Bedi enung u. Ei nstellungen/KÜ_Bedi enung @ 0\mod376_2.doc x @ 5705 @ @ 1
3
Operation
Pos : 20 /99 g erätes pez. M odul e/PG3 Gal abau/FSZ/Bedienung u Eins tell_FSZ-M @ 1\mod836_2.doc x @ 14487 @ @ 1
3.1 Adjustment gripping range
Adjust the device (FSZ-M) over the gripping range adjustment in compliance with the dimensions of the gripping
good (hollow slope block).
●
Remove both wing nuts (1) and pull the threaded bolts (2) out.
●
Move the gripping arm (3) to the corresponding hole in the gripping range adjustment (4).
●
The adjustment of the gripping range must be always symmetrical on both sides. Otherwise the device hang
inclined.
●
Insert the threaded bolts (2) and fasten the wing nuts (1) again.
●
Both adjusting chains (5) must be tightening taut when the device (FSZ-M) stands without a gripping good
("empty") on the ground. The rubber grippers (6) should be in rectangular position (approx.) to the ground. The
adjusting chains (5) must be fit each with the same chain link, so that both have the same length.
3.2 Adjustment handle
The handle (for 2-man operation) can be rotated round 90°.
●
Remove the splint pin (A) and pull the socket pin (B) out.
●
Remove the handle (C), rotate it round 90° and set it in again.
●
Stick the socket pin (B) in again and secure it with the splint pin (A).
Danger of squeezing the hands during adjustments on the device!
11 / 15
Contents
V3
DE
Advertisement
Table of Contents
