Raven CR Series Installation Manual page 25

6. Tap the first thread in the hole drilled into the
front axle using a M6 screw-thread tapping
attachment. Now fasten the strip with one M6
bolt (Figure 23).
7. Drill the second hole in the front axle with a 5
mm drill bit. Remove the strip again and tap
the second screw thread in the hole in the
front axle.
8. Drill the second hole in the wheel angle sensor
strip with 6 mm drill bit. Fasten the strip with
two M6 bolts.
9. Make sure the sensor disc falls nice and flat
into the sensor housing and the strip also lies
flat and under tension on both sides of the disc
positioned against the sensor housing. Press
with your thumb against the end of the strip
and check if the strip bounces back easily
without friction (Figure 30 and Figure 30). The
sensor disc may only have a little bit of friction
in the sensor housing.
10. If necessary, bend the strip a little bit. Two
Bahco's are useful tools to do this (Figure 24).
11. Remove the strip again and mount the sensor
disc on the bottom of the strip (Figure 25).
12. Mount the strip again with two M6 bolts on the
front axle.
13. Check if the sensor disc is properly centered
with the sensor housing. The strip has to lie flat
under slight pretention against the sensor
housing (Figure 25). Also turn the wheels to
make sure the sensor housing remains properly
centered in various wheel positions.
PAGE 25/36 | Installation manual | 016-8000-014EN | Rev. A1
STEERING SYSTEM INSTALLATION | CRX + SC1 | RAVEN EUROPE GENERIC
FIGURE 23 STRIP ON THE FRONT AXLE WITH ONE
FIGURE 24 BEND THE STRIP WITH THE HELP OF
FIGURE 25 DISC AT THE OTHER SIDE OF THE STRIP
BOLT
TWO BAHCO'S.