Raven CR Series Installation Manual page 13

If necessary the positive and negative wires, in

between the battery and the fuses, can be
shortened. Be sure to use cable sockets with
the correct size for proper connection.
If a ground switch is used, connect the wiring

harness behind the ground switch (not at the
battery side of the ground switch!).
If a main (12V) switch is used in the red wire,

connect the wiring harness behind the main
switch (not at the battery side of the main
switch!).
If no main switch is used, always connect the

wiring harness directly to the battery.
If the system is connected to a 24 Volt

machine, always use a 24V to 12V converter.
Never connect between the two batteries of a
24V machine!
Lead the terminal harness along with the GPS

and radio/GSM antenna cables through one
pillar of the cab.
Tie-wrap the wires so they are attached free

from vibration and friction.
Caution! :
It is important to ensure that the wiring harness
is always connected to the battery AFTER
installing all wires and controllers!
PAGE 13/36 | Installation manual | 016-8000-014EN | Rev. A1
STEERING SYSTEM INSTALLATION | CRX + SC1 | RAVEN EUROPE GENERIC