System Requirements; Board Setup; Figure 2. X-Nucleo-Out02A1 Expansion Board Connected To An Stm32 Nucleo Development Board - ST X-NUCLEO-OUT02A1 User Manual

Figure 2.
The X-NUCLEO-OUT02A1 has been designed to be used with
•
•
•
1.3

System requirements

To use the
•
•
•
•
1.4

Board setup

Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Step 7.
UM2507 - Rev 1
Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from
X-NUCLEO-OUT02A1 expansion board connected to an STM32 Nucleo development board
NUCLEO-F103RB
NUCLEO-F302R8
NUCLEO-F401RE
STM32 Nucleo boards with the
a Windows PC/laptop (Windows 7 or above) to install the firmware package (X-CUBE-OUT02)
a type A to Mini-B USB cable to connect the STM32 Nucleo board to the PC
an STM32 Nucleo development board (NUCLEO-F103RB,
an X-NUCLEO-OUT02A1 expansion board
Connect the micro-USB cable to the PC.
Download the firmware version onto the microcontroller.
Set the following jumper configurations on the
– Close SB62 and SB63 jumpers
– Open SB13 and SB14 jumpers
Connect the ISO8200AQ
Provide the digital supply voltage.
– when connected to the PC: keep the micro-USB cable connected and close jumper JP5 on the
STM32 Nucleo board between pins 1 and 2.
– in standalone mode: provide a 7 to 12 V external supply via J2 on the X-NUCLEO- OUT02A1 and
close jumper JP5 on the STM32 Nucleo board between pins 2 and 3.
Connect the load on the output connector.
Run the STM32 and push the blue button on the STM32 Nucleo board to select the example provided
in the firmware package.
X-NUCLEO-OUT02A1
NUCLEO-F302R8
STM32 Nucleo
device supply voltage to the
System requirements
expansion board you need:
or NUCLEO-F401RE)
board:
X-NUCLEO-OUT02A1 via J1.
UM2507
page 3/14