Table of Contents
Advertisement
2. Maintanance
2.1
Control panel
information about instantaneous/set temperature
mode information
breakdown information
information about parameters setting
point is lighting = setting
point is not lighting = operation
change of the parameter set
change o the parameter set
2.2. Boiler switching ON/OFF
Is done with the switcher 0/1 placed on the lower side of
boiler in the right lower corner (see the picture 1.6).
After boiler switching on you can see information on the
display:
†EL -
Electric Easy
- type of the boiler
†6A - software number
†1.0 - software modification ( např. 1.0)
The switch board and inlet supply
connectors of clamps and the inlet
supply connector are under voltage!
Disconnect the boiler from the main
inlet supply.
2.3 Modes
Important knowledge for setting:
†During temperature setting the point between
numbers are lighting.
†During pause longer than 5 s the boiler returns to point
before setting.In case of mistake setting (for example
parameters) it is possible to wait 5 s and the boiler
returns back or it is possible to push the button ENTER
8 .0 .
+
-
point is lighting = only 1 heating
element is on
point is not lighting = no heating
element is on
point is blinking = below/overvoltage in
supply net
short pushing
- setting confirmation in memory
- return from the mode Stand-by
- frame for parameters setting
long pushing (approx. 3 s)
- going to mode Stand-by
information about instantaneous
pressure of heating system.
without setting (without using / ,the boiler returns
to mode before setting.
†Hold the button
or
automatically up
or down .
2.3.1 Operation mode heating heating water
on the display there is instantaneous temperature.
Without the room thermostat connected
5
4
and the value will role
6
5
1 - boiler
4 - heating system
5 - shut off valve
6 - filter
11
Advertisement
Table of Contents
