Hyundai Ioniq Hybrid 2020 Owner's Manual page 178

4. Press and hold the just-trained
HomeLink ® button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your device should activate.
5. To program the remaining two
HomeLink ® buttons, follow either
steps 1 through 4 above for other
Rolling Code devices or steps 2
through 5 in Standard Programming
for standard devices.
Standard programming
To train most devices, follow these
instructions:
1. For first-time programming, press
and hold the two outside buttons,
HomeLink ® Channel
Channel 3 Buttons, until the indi-
cator light begins to flash (after 20
seconds). Release both buttons.
Do not hold the buttons for longer
than 30 seconds.
2. Position the end of your hand-held
transmitter 2-8 cm (1-3 inches)
away from the HomeLink
while keeping the indicator light in
view.
3. Simultaneously press and hold
both the HomeLink ® and hand-
held transmitter button. DO NOT
release the buttons until step 4
has been completed.
4. While continuing to hold the but-
tons the red Indicator Status LED
will flash slowly and then rapidly
after HomeLink ® successfully
trains to the frequency signal from
the hand-held transmitter. Release
both buttons.
5. Press and hold the just-trained
HomeLink ®
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your device should activate when
1 and
the HomeLink
and released.
6. To program the remaining two
HomeLink ®
through 5.
®
buttons
button and observe
®
button is pressed
3
buttons, follow steps 2
3-31