Hyundai Ioniq Hybrid 2020 Owner's Manual page 177

Convenient features of your vehicle
®
Programming HomeLink
Please note the following:
• When programming a garage door
opener, it is advised to park the
vehicle outside of the garage.
• It is recommended that a new bat-
tery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink ® for quicker
training and accurate transmission
of the radio-frequency signal.
• Some vehicles may require the igni-
tion switch to be placed in the ACC
(or "Accessories") position for pro-
gramming and/or operation
®
HomeLink .
• In the event that there are still pro-
gramming difficulties or questions
after following the programming
steps listed below,
HomeLink ® at: www.homelink.com
or by calling 1-800-355-3515.
3-30
Rolling code programming
Rolling code devices which are
"code-protected" and manufactured
after 1996 may be determined by the
following:
• Reference the device owner's
manual for verification.
• The handheld transmitter appears to
program the HomeLink
Transceiver but does not activate the
device.
• Press and
HomeLink button. The device has
the rolling code feature if the indi-
cator light flashes rapidly and then
of
turns solid after 2 seconds.
contact
To train rolling code devices, follow
these instructions:
1. At the garage door opener receiv-
er (motor-head unit) in the garage,
locate the "learn" or "smart" but-
ton. This can usually be found
where the hanging antenna wire is
attached to the motor-head unit.
Exact location and color of the but-
® Universal
ton may vary by garage door
opener brand. If there is difficulty
locating the training button, refer-
hold the trained
ence the device owner's manual or
please visit our Web site at
www.homelink.com.
2. Firmly press and release the
"learn" or "smart" button (which
activates the "training light"). You
will have 30 seconds to initiate
step 3.
3. Return to the vehicle and firmly
press, hold for two seconds and
then
HomeLink
"press/hold/release" sequence a
second time to complete the pro-
gramming. (Some devices may
require
sequence a third time to complete
the programming.)
release the desired
® button. Repeat the
you to repeat this