I-Tech PHYSIO 4 User Manual page 83

COMPATIBILITY ELECTROMAGNETIC TABLES
Guidance and manufacturer's declaration – ELECTROMAGNETIC EMISSIONS – FOR
The I-TECH PHYSIO 4/EMG is intended for use in the electromagnetic environment
specified below. The customer or the user of the I-TECH PHYSIO 4/EMG should
assure that it is used in such an environment.
Emissions Test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonics emissions
IEC 61000-3-2
Voltage
fluctuation/flicker
emissions
IEC 61000-3-3
Guidance and manufacturer's declaration – ELECTROMAGNETIC IMMUNITY – FOR ALL
The I-TECH PHYSIO 4/EMG is intended for use in the electromagnetic environment
specified below. The customer or the user of the device should assure that it is used in
such an environment
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IACER Srl
ALL EQUIPMENT AND SYSTEMS
Compliance
Group 1
Class B
Class A
Compliant
EQUIPMENT AND SYSTEMS
Test level
IEC 60601
±6kV; +8kV in
±6kV; +8kV in
contact
contact
±8kV; +15kV on
±8kV; +15kV on air
air
±2kV ±2kV
for power for power supplies
Electromagnetic environment -
The I-TECH PHYSIO 4/EMG uses RF
energy only
function.
emissions are very low and are not
likely to cause any interference in
nearby electronic equipment.
The I-TECH PHYSIO 4/EMG is
suitable
establishment
establishment directly connected
to the public low-voltage power
supply network
buildings
purposes.
Compliance level
79
guide
for its internal
Therefore, its
for domestic
and
that supplis
used for domestic
Electromagnetic
environment - guide
Floors should be wood,
concrete or ceramic tile.
If floors are covered with
synthetic material, the
relative humidity should
be at least 30%.
Mains power
should be that of a typical
MNPG178
RF
in
quality