Patient Preparation - I-Tech PHYSIO 4 User Manual

Should you notice any changes in the device's performance during
treatment, interrupt the treatment immediately and consult the retailer or
manufacturer.
If the stimulation is uncomfortable decrease intensity. If the
problem persists consult a doctor.
Some patients could suffer from skin irritation or oversensitivity
due to stimulation or gel. If the problem persists, suspend the
stimulation and consult a doctor.
Consult a doctor before using I-TECH PHYSIO4/EMG with metallic
osteosynthesis devices.
IF YOU HAVE ANY DOUBTS REGARDING THE DEVICE USE CONSULT YOUR
DOCTOR.

Patient preparation

Before using I-TECH PHYSIO 4/EMG clean the skin of the area to be treated;
with the cable disconnected from I-TECH PHYSIO 4/EMG, connect the
electrostimulation cable jacks to the self-adhesive electrodes; position the
self-adhesive electrodes on the skin (see photos of electrode positions in the
Positions manual); connect both cables to the relative jacks CH1/CH2 or
CH3/CH4 (the software, for safety, requires the connection of all therapy
cables) for each program selected the display will show the active channels
and the type of cable to be inserted (refer to the table below).
The type of cable is screen-printed on each cable connector as shown in the
photo:
IACER Srl
Type of cable
TYPE 1 From W01 to W26
From R01 to R25
From E01 to E17
From M01 to M18
TYPE 2 W27
TYPE 3 C01
Figure 1 – Cable type.
13
Program
MNPG178