Device Use; Instructions On Use For A Single Patient - I-Tech PHYSIO 4 User Manual

Make sure that I-TECH PHYSIO4/EMG is switched off before
disconnecting the electrodes at the end of the treatment.

Device use

Instructions on use for a single patient

1. Turn on I-TECH PHYSIO 4/EMG by pressing ON/OFF button on the
small rear panel of the device.
2. Select single mode and press the OK key to confirm.
3. Select the program group: Wave, Rehab, EMS or MEM, using the
right and / or left arrow keys.
4. Select the program using the up/down arrow buttons (e.g.E03 basic
strength).
5. Select male or female with the right / left arrow keys (when
applicable).
6. Select the muscle group with the up/down buttons.
arms trunk
male male
7. Press the OK key to start stimulation and the relative text appears on
the screen; place the electrodes on the skin, connect the cables, and
increase the intensity; the type of cable required for the selected
type of treatment also appears on the screen. To start the work
session, press the Up arrow key of at least one of the channels used
for electrostimulation, and increase the intensity of the output
current; the I-TECH PHYSIO 4/EMG opens the work screen
automatically, displaying the name of the selected program.
8. Press the up arrow button for each channel in use to increase
current intensity until the personal tolerance level is reached
(stimulation comfort).
IACER Srl
Select
male
Legs
male
14
arms trunk
female female
Select
female
legs
female
MNPG178