Table of Contents
Advertisement
Maintenance
If used following the instructions given in this user guide, the equipment
does not require any particular kind of maintenance.
It is recommended that the manufacturer carries out a functional test
every 24 months. The manufacturer does not consider the I-TECH PHYSIO
4/EMG device repairable by any personnel outside the company. Each
operation of the kind perpetuated by personnel not authorized by the
manufacturer will be considered as tampering the device, freeing the
manufacturer from granting warranty and from any danger that the user or
the operator may be exposed to.
CLEANLINESS
Clean the device using only a dry soft cloth. Resistant strains can be removed
using a sponge soaked in solution of water and alcohol, do not use detergents
or other aggressive agents.
ATTENTION: the device must not be cleaned while the device is in
operation. Disconnect the device from the charger, disconnect all
connection cables and perform cleaning with the device switched
off.
Device not subject to sterilization.
Note:
−
Never use solvents for cleaning. Cleaning agents cause damage to
the device.
Attention to the need for periodic maintenance, especially:
−
•
inspection of main body for cracks, which may allow the
ingress of conductive fluid;
•
inspection of the main cable and associated connectors.
Only follow the instructions above, contact the manufacturer for any other
cleaning / maintenance operations.
TRANSPORTATION AND STORAGE
Protect the device from high temperature, direct daylight and liquids.
The devices are designed to operate under the following environmental
conditions:
Temperature
Relative humidity
Pressure
IACER Srl
from +10 to + 40 °C
from 15 to 93%
from 500 to 1060hPa
73
Device' s care
MNPG178
Advertisement
Table of Contents
