Table of Contents
Advertisement
Configuring the RAID system
Fibre Settings
The Channel Speed Settings for all the controller ports are set at the factory
default value of 1 GB/s.
Caution! Do not, under any circumstances, select the Auto Neg. option.
If you are using a 2 GBit/s Host Bus Adapter (HBA), fix the Channel Speed
Settings at 2 GBit/s.
Caution! Do not, under any circumstances, use the Auto Neg. option on the
HBA.
At this point only set the necessary Controller Speed Settings. Do not set the
Disk Channels option.
The Disk Channel setting affects the internal magnetic disk interfaces only and
is fixed at 2 GB; leave it at this setting.
Do not, under any circumstances, change the setting in the Frame Size Control
box.
35
U41578-J-Z875-1-76
Advertisement
Table of Contents
