Cabinet Id - Fujitsu FibreCAT S80 Manual

Appendix

Cabinet ID

Each FibreCAT S80 system can be assigned a unique number in the software.
Each shelf is assigned a Cabinet ID number; the complete system takes the
number of the controller shelf. The number is stored on the back plane of the
shelf.
IMPORTANT: The Cabinet ID is not the Shelf ID. The Shelf ID is set on the
hardware at the back of the shelf.
The menu tree on the left-hand side of the Welcome page shows the Cabinet
ID (240 in the example below). This is the number of the S80 RAID controller
(i.e. of the lowest shelf in the rack). The letter R in the controller icon indicates
that this is the main controller and that the name of this controller is given to the
entire cabinet. JBOD expansion units are indicated by the letter J inside the
icon.
There are cases where it will be necessary to change the Cabinet ID. If the
same number occurs twice in the system you must change the Cabinet ID (240
here in our example). Shelfes with the same number are displayed once only
and any duplicates will be suppressed and not displayed.
It will also be necessary to change this number in cases where the factory
mistakenly supplies two systems with the same number.
71
U41578-J-Z875-1-76