Table of Contents
Advertisement
RAID wizard
With the FibreCAT S80 you can set the stripe size once only. The stripe size
selected is then valid for all the LUNs in the FibreCAT S80 system. If you click
the check box under Init (Fg) this will start foreground initialisation. You must
select this option with version 8.20 of the RAID controller firmware. Foreground
initialisation starts automatically when you leave the configuration procedure.
IMPORTANT:
The system cannot be accessed during foreground initialisation. On full-
configuration systems (56 HDDs /4.1 TB), foreground initialisation can last
as much as four days.
You must always create a „Mini-LUN 0" of 10 MByte for Cluster and/or
Server View reasons. This LUN 0 shall be visible for all nodes in a cluster.
The Mini-LUN shall not be grouped in any failover Group (i.e. DDM).
Use the Logical Drive button to add and configure further logical drives.
If you create more than one LUN, the LUN numbering has to be in an ascending
order. No "gaps" are allowed. If you leave "gaps", you will be in trouble, if later
LUNs will be added.
44
U41578-J-Z875-1-76
Advertisement
Table of Contents
