Rs232 / Rs485 Communication - Honeywell Gent Vigilon Installation Instructions Manual

RS232 / RS485 Communication

The control panel offers RS232 and RS485 communication via the IO card.
A standard IO card (not supplied) must be inserted in slot P2 of the backplane of the
panel, which facilitate RS232 and RS485 communication via terminal block P4 on
Terminal card. Note RS232 is PORT 0 and RS485 is PORT 1 when an IO card is fi tted
in slot P2. The domain address and communication baud rate are confi gured by setting
the DIL switch located on the left edge of the Display Keyboard card.
Terminals for IO card
in slot P2 of the backplane
NOTE: These port settings are
displayed when viewing MCC status.
IO, Network or
Loop card option
NETWORK CARD IN SLOT P8
0V1 +VE1 -VE1 0V2 N/C +VE2 -VE2 N/C
LOOP CARD IN SLOT P8 (Loop 6)
IO CARD IN SLOT P8
A 5V B
PB1
MCC / LCC
I/O or N/W
LOOP or RS232
LOOP or RS232
LOOP or RS232
LOOP or RS232
LOOP or RS232
LOOP, N/W or I/O
Backplane
PANEL
www.acornfiresecurity.com
PORT 1
IO card
RS485
A 5V B 0V
Terminal card
PANEL
IO or Loop card option
LOOP CARD IN SLOT P7 (Loop 5)
L1 0V L2 0V
0V CTS Rx RTS TX
PB2
- P1
- P2
- P3
- P4
- P5
- P6
- P7
- P8
www.acornfiresecurity.com
PORT 0
RS232
Tx CTS Rx RTS
P4
IO (RS232) CARD IN SLOT P7
N/C 0V CTS RX RTS TX
L1 0V L2 0V
Vigilon fire system
31