S-Quad Sensors - Honeywell Gent Vigilon Installation Instructions Manual

On completion of wiring installation

S-Quad Sensors

This following is short information on the S-Quad product range. The S-Quad product
integrates dual angle smoke, heat and carbon monoxide gas detection with electronic
sounder, speech and LED fl asher in one assembly.
Full information on S-Quad Devices can be downloaded from www.gentexpert.co.uk by
registered users.
Base
The base has terminals for external cables, for the wiring of loop circuit and monitored
input or output circuit. Any S-Quad device can be plugged into an S-Quad base.
IP21 Base
A IP21 Base Gasket prevent water damage from dripping water from the ceiling.
An optional label (Part No: 805576) can be fi tted to the base. The label can be marked
up with device location information.
Indicators
The S-Quad has a red LED that gives an indication in the event of a fi re. The LED can
be confi gured to fl ash periodically, as an 'in operation' confi rmation, this indication is
given system-wide at all S-Quads. The S-Quad with a CO sensor also has a blue LED
to indicate when a fi re signal senses the presence of CO.
Dust Cover
A dust cover is supplied with the S-Quad, to prevent dust from building work
contaminating the sensor. The cover is removed prior to the commissioning of the fi re
alarm system.
40
www.acornfiresecurity.com
www.acornfiresecurity.com