Keypad Functions - Cardinal 185 Installation And Technical Manual

The Model 185 and 185B Weight Indicators are equipped with a 7-key keypad. The keypad is
used to enter commands and data into the indicator. This section describes each key along
with its normal function. It is helpful to refer to the actual indicator while reading this section.
The membrane keypad is not to be operated with pointed objects (pencils,
pens, fingernails, etc.). Damage to keypad resulting from this practice is NOT
covered under warranty.
ON/OFF
Pressing this key when the indicator is off will apply power to the indicator.
Pressing this key when the indicator is on will turn the indicator off.
The following key functions are available if the 185 or 185B are functioning as a weight
indicator and not as a remote display.
ZERO
Pressing this key will perform a zero-load adjustment. The adjustment will not
take place unless the weight display is stable. There is a setup option to limit
the amount of adjustment to plus or minus two percent of scale capacity.
TARE  (Enter)
Pressing this key will set the tare weight to the current gross weight. The
display indication will switch to net weight display mode if the tare weight is
not zero. The weight display must be stable for the operation to occur.
NET/GROSS
If the tare weight is greater than zero, pressing this key will toggle between
the gross and net weight display modes.
8400-0181-OM Rev C  185 and 185B Installation & Technical

KEYPAD FUNCTIONS

Figure No. 10
11