Table of Contents
Advertisement
Installation
Installation
To avoid personal injury, be especially careful when
connecting the high pressure material supply system
and always keep clear of the nozzles when test spray-
ing.
Before starting installation of the Graco 3D gun, refer to
the Description on page 5 and Component Identifica-
tion on page 6, in order to be familiar with the various
parts of the applicator.
To ensure a trouble free operation of the applicator, it is
very important that the unit is properly installed on the
robot. It is also very important that the function of the
applicator is carefully checked before start up.
Graco recommends using the tools supplied in kit
17V859 (sold separately) for convenience and correct
fit.
Typical Applicator Installation
The following parts are normally required:
•
1 pc. Graco 3D gun with nozzle head and nozzle
cap.
•
1 pc. Robot mounting flange.
•
1 pc. Swivel locking bracket.
•
1 pc. Cable with 18-pin connector (other configura-
tions possible).
•
6 pcs. M6x16 mm hex socket head screws with
extra low head.
•
2 pc. Guide pin Ø 6 mm
•
3 pcs. M6x20 mm hex socket head screws.
•
4 pcs. M5x14 hex socket head screws.
Begin the installation by mounting the mounting flange
(see page 13) on the sixth axis of the robot using the six
M6x16 screws with extra low heads. When the flange is
fixed on the robot, the applicator is attached to the
flange with the three M6x20 screws. It is important to
check that the guide pins are inserted in the right posi-
tions.
14
When the applicator is mounted to the robot, the swivel
locking bracket (two options are available) must be
attached to the connection housing and to the fixation
point on the robot using the two M5X14 hex head
screws.
Swivel Locking Bracket Option 1:
Swivel Locking Bracket Option 2:
F
. 11
IG
The swivel locking bracket option used depends on how
the applicator is attached to the robot arm. Use the first
option when routing the cable from the top, and use the
second option when routing the cable from the bottom.
Standard parts fitting the ABB swivel locking bracket are
available, and other non-standard parts can be made
available upon request.
3A5591D
Advertisement
Table of Contents
