Advertisement
Installation
Installation
NOTE: Be sure to install a fluid shutoff valve, located
close to the dispenser bar, to shut off fluid to the dis-
penser when servicing.
Refer to the Parts Drawing on page 6 to assembly the
dispenser. The numbers in parentheses in the text refer
to the numbers in the Parts Drawing.
COMPONENT RUPTURE HAZARD
• Do not exceed 900 psi (3.4 MPa, 34 bar) fluid
pressure to the dispenser.
• Do not exceed 500 psi (6.2 MPa, 62 bar) fluid
pressure to the dispenser with a meter kit.
Exceeding this pressure could cause the
component to rupture and result in serious injury.
A thermal pressure relief kit (235998) is required
in closed systems that use this meter kit.
Assembly
1. Slide strainer (14) into the front of the drain pan
(15).
2. Slide the back panel (12) into the drain pan (15) and
secure it with screw (5), lockwasher (2) and nuts (1).
3. Screw the pipe plug (4) into the bottom of the drain
pan (15).
4. Mount the dispenser on the wall with the washers
(7) and other suitable hardware.
NOTICE
Be sure the wall and mounting hardware used can
support the combined weight of the dispenser, fluid,
receiving containers, and any other stress caused
by operating the valve. Allow enough room under
the drain pan (15) to drain fluid into a container.
NOTE: Extra washers (7), screw (5), locker washers (2),
and nuts (1) are included for connecting the sides of two
dispenser bars together. See the DETAIL in the Parts
Drawing on page 6.
5. Insert the adapter (8) through the front panel (11).
6. Screw the manifold (13) onto the adapter (11).
4
7. Secure the manifold to the front panel with two lock-
washers (2) and screws (5).
8. Screw the valve (16) onto the adapter (8). Make
sure the valve's outlet points down.
9. Screw the swivel union (9) into the manifold (13).
10. Connect the front panel (11) to the back panel (12)
with the screws (5), lockwashers (2), and nuts (1).
11. Plug each unused hole in the front panel (11) with
screws (5) and lock washers (2), the 7/8 in. button
plugs (3), or the 1-1/16 in. button pugs (6), as appro-
priate.
NOTE: A Solenoid Valve and Ready Light Kit are avail-
able for signaling when an order is ready to dispense.
See Accessories on page 8.
12. Connect the fluid line to the swivel union (9).
307742P
Advertisement
