Configurations Of The Alx 73X -28; Functionality -28 - Novexx Solutions ALX 73 Series User Manual

ALX 73x
User Manual
Configurations of the ALX 73x
The ALX 73x can be adjusted in many ways to meet customer requirements:
Feature
Direction in which products move
Assembly position of the machine
Machine fastening
Number of unwinders
Fastening of unwinders
[Tab. 16] Options for configuring the ALX 73x.
Operation of the ALX 73x is described in this manual based on a machine with the following config-
uration:
• RH
• Horizontal installation position for labelling from above
• 1 Unwinder top left
For additional configuration illustrations see section
Functionality
The main function of the ALX 73x is printing and dispensing self-adhesive labels. This function is
performed by a printing [8C] and a dispensing [8B] module that will be referred to below by the
shortened form printer and dispenser.
The printer and dispenser work largely independently of each other. The only information ex-
changed between the units relates to ready for operation status and error states that occur. These
units have their own control unit, firmware and control panel. To be able to operate the machine,
the two units must be set up separately from each other. In some cases the same settings will have
to be made twice (for example entering the label length).
The labels are not dispensed immediately after printing. Instead they are buffered in a loop where
they are kept under tension by the dancer unit [8D].
08/2017 | 01
Adjustment
Selection of design: LH / RH
Horizontal / vertical (for labelling from above or
from the side)
Below / in the rear
1 / 2
Above (to the right / left)
On the side (right / left)
Threading diagrams 
28
on page 73.
Product description