10.0 Operation And Inspection Checklist - Task Force Tips Master Foam Series Instructions For Installation, Operation And Maintenance

Fixed gpm self-educting foam nozzle

Hide thumbs Also See for Master Foam Series:

Table of Contents

10.0 OPERATION AND INSPECTION CHECKLIST

BEFORE EACH USE, the nozzle must be inspected to this checklist:

1. There is no obvious damage such as missing, broken or loose parts, damaged labels etc.

2. Waterway is clear of obstructions

3. Coupling is tight and leak free

4. Gaskets are in good condition

5. Shaper turns freely and adjusts pattern through full range

6. Nozzle flow is adequate as indicated by pump pressure and nozzle reaction

BEFORE BEING PLACED BACK IN SERVICE, nozzles must be inspected to this checklist:

1. All controls and adjustments are operational

2. There are no broken or missing parts

3. There is no damage to the nozzle that could impair safe operation (e.g. dents, cracks, corrosion or other defects)

4. The thread gasket is in good condition

5. The waterway is clear of obstructions

6. Nozzle is clean and markings are legible

7. Coupling is retightened properly

8. Shaper is set to desired pattern

WARNING

TASK FORCE TIPS LLC

MADE IN USA · tft.com

Equipment failing any part of the checklist is unsafe for use and must have the problem corrected

before use or being placed back into service. Operating equipment that has failed the checklist is a

misuse of this equipment.

3701 Innovation Way, Valparaiso, IN 46383-9327 USA

800-348-2686 · 219-462-6161 · Fax 219-464-7155

LIZ-030 October 29, 2020 Rev13

Table of Contents

Do you have a question about the Master Foam Series and is the answer not in the manual?