Installation - Kanmor Mixing Control 362e Data Brochure

Installation

CAUTION
Improper installation and operation of this control could result in damage to the equipment and possibly even personal injury.
It is your responsibility to ensure that this control is safely installed to all applicable codes and standards. This electronic
control is not intended for use as a primary limit control. Other controls that are intended and certified as safety limits must
be placed into the control circuit. Do not open the control. Refer to qualified personnel for servicing. Opening voids warranty
and can result in damage to the equipment and possibly even personal injury.
STEP ONE GETTING READY
Check the contents of this package. If any of the contents listed are missing or damaged, please contact your wholesaler or
kanmor sales representative for assistance.
Type 362e includes:
Note: Carefully read the details of the Sequence of Operation to ensure that you have chosen the proper control for your application.
STEP TWO MOUNTING THE BASE
Press down at the fingertip
grips on top of the front cover
and pull out and down.
Remove the safety dividers
from the wiring chamber by
pulling them straight out of
their grooves.
The control can be mounted
on a standard DIN rail. This
will be a popular option for
those who prefer to mount
the control inside a larger
electrical panel.
One Mixing Control 362e, One Outdoor Sensor 070e, Two Universal Sensors 071e
Data Brochures D 362e, D 070e, User Brochure U 362e, Essay E 007e.
Lift the front cover up and
away from the control.
Control release clip
Press the control release
clip on the base inside the
wiring chamber and slide
the control upwards.
Loosen the screws at the
front of the wiring cover.
The control lifts up and away
from the base.
The wiring can enter the
bottom or the back of the
enclosure. Knock-outs pro-
vided in the base allow the
wiring to be run in conduit
up to the enclosure. The
base also has holes that line
up with the mounting holes
of most common electrical
boxes.
11 of 32
The wiring cover pulls
straight out from the
wiring chamber.
13 Mounting holes
Control
release
clip
The base is ready for
mounting. There are 10
conduit knock-outs at
the back and bottom of
the wiring chamber.
© 2003 D 362e - 06/03