Step 3 - Install Mm3 & Reassemble Device - Command access SLP-UL-M-KIT Installation Instructions Manual

STEP 3
- Install MM3 & Reassemble Device
A. Slide push pad with motor kit back into the device. Also, the filler plate must be slid in at same time.
B. Make sure Latch retractor is pressed down so push pad slides over it.
C. Re-install original screws in holes 1 & 2. Install new screws provided in holes 3 & 4.
Step 1
-
Select your preferred torque mode (ships in standard torque) Press the
device push pad to the desired setting. (Recommend to fully depress and
release 5%, giving the device room for changing door conditions.)
Step 2
-
While depressing the push pad, apply power. (i.e. Presenting the
credential to the reader).
Step 3
-
Continue to keep pad depressed, the device will beep 6 times. After
the beeps have stopped, release the pad and now the adjustment is
complete. If not to your liking repeat the 3 steps.
Step 4
-
Once you found the correct location, flip the dip switches to off to lock programming.
S ptS
etting
S p
witch rogram
1
2
ON OFF Low Torque
OFF ON Standard Torque
ON ON High Torque
OFF OFF PTS programming locked