Table of Contents
Advertisement
6.6.2 Wiegand output
The module can be configured into a standard reader with a
or 44 bits format for
EM Marin
setting first (see chapter 6.5.1), after that they are sent in the output format. When the reader
module operates in the Wiegand output operating mode, the I/O Port (tab. 5) is used as an
input for monitoring an external device tamper status.
ID media technology
EM Marin
Two long beeps and the red LED lit feature powering up the module. The green LED blink
indicates an ID reading.
Individual signals function in
Input 1
Input 2
Output 1 (transistor)
Since the
FW version 5.09
implemented, enabling to
offers the
Wiegand data interface synchronization
6.6.3 Wiegand input (entry reader)
The module can be configured into a mode of controlling the door from both sides
reader
mode).
In the
entry reader mode
interface
acquires a
standardly, the reason codes equal zero.
When the reader module operates in the entry reader operating mode, the I/O Port (tab. 5)
is used as an output for controlling the entry reader buzzer.
Since the
FW version 5.09
implemented, enabling to
offers the
Wiegand data interface synchronization
The
WIEGAND input
6.7 Programming mode
The module enters programming mode by reading one of the two
"+" and "-"). The programming mode cannot be entered while the module is in hardware
technology ID media. Read IDs are formatted with the previous
Available configuration of the WIEGAND output format
26bit, 32bit, 42bit, 44bit
Table 9: ID media format in WIEGAND operating mode
WIEGAND output
Beeper control (0 V active)
Yellow LED control (0 V active)
Tamper signaling; it follows the alarm state of tamper sensors
(tamper signal = transistor switched on)
Table 10: Signal function in WIEGAND operating mode
the reading synchronization of a
cancel the mutual disturbance
an identification at an external reader connected via the
reason code
255; at the same time the reader module operates
the reading synchronization of a
cancel the mutual disturbance
and
WIEGAND output
Page 12
WIEGAND output
operating mode is described in table 10.
couple of TECHFASS readers
of the modules. The reader module
in
MASTER
mode.
couple of TECHFASS readers
of the modules. The reader module
in
SLAVE
mode.
operating modes are mutually exclusive.
programming cards
in 26, 32, 42
3)
is
(entry
WIEGAND
is
(cards
Advertisement
Table of Contents
