Programming Mode - TECHFASS MREM 79 User Manual

6.7 Programming mode

The module enters programming mode by reading one of the two
(cards "+" and "-"). The programming mode cannot be entered while the module is in
hardware address setting mode (for modules with HW address setting via the
communication line). The module's functionality in programming mode can be seen in
pictures 4 a-d.
It is not possible to use time schedules when inserting cards in programming mode,
therefore cards are always valid.
6.7.1 Inserting cards into the reader's memory
Follow these steps for inserting cards into the reader module's memory:
Step 1
Read the programming card
for inserting: the reader goes
into programming mode.
6.7.2 Deleting cards from the reader's memory
For deleting the cards from the reader module's memory use following steps:
Step 1
Read the programming card
for deleting: the reader goes
into programming mode.
Step 2
One by one, read the cards
which are to be granted
access.
Pic.4 a): Inserting cards
Step 2
One by one, read the cards
which are to have their
access revoked.
Pic.4 b): Deleting cards
Page 13
programming cards
Step 3
About 15 seconds after
inserting the last card the
reader module goes back
into standard operating
mode.
Step 3
About 15 seconds after
deleting the last card the
reader module goes back
into standard operating
mode.