Id Expiration Function; Id With Alarm Flag Function - TECHFASS APS mini Plus MREM 65 Series User Manual

•
Card 4 gets lost
from chapter 6.7.3 – Read
programming card
Register the change in your
position
1
2
3
4
5
•
It is necessary to
chapter 6.7.1 again. 1 – Read
s the programming mode is exited.
A new card is always inserted at the position after the last inserted card. In case of deleting
all cards using the procedure described in chapter 6.7.4, it is necessary to create a new filing
table.

6.8 ID expiration function

This function is implemented since the FW version 5.0.
It is possible to set an
occurs, the ID becomes invalid (expired). The expiration evaluation is performed on every
date change in the module's RTC and when the access rights are downloaded.

6.9 ID with Alarm flag function

This function is implemented since the FW version 5.0.
It is possible so set an
relevant alarm is raised (and the alarm output is switched for preset time).
– Delete it
using the card
+ (inserting) programming
again, then card
table.
card
card 1
card 2 (available)
card 3
card 4 (lost)
card 5
Pic.5 g): Deleting card 4 using the card 2, table after deleting card 4
add another card
+ (inserting) programming
position
1
2
3
4
5
6
Expiration date for every
Alarm – ID flag
for every
Page 16
2, which is available, and using the procedure
2, and finally + (inserting) programming card
position
1
2
3
4
5
(card 6). We proceed with the procedure from
Register the change in your
card
card 1
card 2
card 3
card 4
card 5
card 6
Pic. 5 h): Table after inserting card 6
ID stored in the module. When the date
ID stored in the module. When the ID is read,
card, then 5x + (inserting)
card
card 1
card 2
card 3
card 4
card 5
card, read cards 1-5, after 15
table.
again.