TECHFASS APS mini Plus MREM 65 Series User Manual page 13

address setting mode (for modules with HW address setting via the communication line). The
module's functionality in programming mode can be seen in pictures 5 a-d.
It is not possible to use time schedules when inserting cards in programming mode,
therefore cards are always valid.
6.7.1 Inserting cards into the reader's memory
Follow these steps for inserting cards into the reader module's memory:
Step 1
Read the programming card
for inserting: the reader goes
into programming mode.
6.7.2 Deleting cards from the reader's memory
For deleting the cards from the reader module's memory use following steps:
Step 1
Read the programming card
for deleting: the reader goes
into programming mode.
Step 2
One by one, read the cards
which are to be granted
access.
Step 2
One by one, read the cards
which are to have their
access revoked.
Page 13
Step 3
About 15 seconds
inserting the last card the
reader module goes back
into standard operating
mode.
Pic.5 a): Inserting cards
Step 3
About 15 seconds
deleting the last card the
reader module goes back
into standard operating
mode.
Pic.5 b): Deleting cards
after
after