Table of Contents
Advertisement
6.4.2 Door Ajar alarm
If the door stays open until the pre-defined Door ajar timeout expires – see Tab. 9, the
"Door Ajar" alarm is activated.
6.4.3 Antipassback alarm
The
Antipassback alarm
running or when the ID is blocked by a
6.4.4 ID with Alarm flag alarm
ID with Alarm flag alarm
6.4.5 Reading ID during alarm state
Reading an ID doesn't affect the alarm state, reading a valid ID only terminates the
acoustic alarm announcement followed by "Door Open" function. Reading an invalid ID only
interrupts the acoustic announcement of the alarm state while signalizing "Invalid ID".
6.5 Standard operating modes
The reader module can be in either
functionality is identical in both operating modes; the events archive is read from the reader
module's memory when the module goes online.
in either online or offline mode), the module goes into programming mode.
6.6 Programming mode
The module enters programming mode by reading one of the two
(cards "+" and "-"). The programming mode cannot be entered while the module is in
hardware address setting mode (for modules with HW address setting via the
communication line). The module's functionality in programming mode can be seen in
pictures 5 a-d.
It is not possible to use time schedules when inserting cards in programming mode,
therefore cards are always valid.
is raised when an ID is read during the
Zone
APB.
occurs when an ID with the Alarm flag is read.
online
Page 15
operating mode. The module's
or
offline
.
When a programming card is read (while
Time APB
counter is
programming cards
Advertisement
Table of Contents
