Remote Node Setup - ZyXEL Communications ZyXEL Prestige 100WH User Manual

Prestige 100WH Internet Access Router
5.1.1

Remote Node Setup

Follow the procedure in
protocol-independent parameters in Menu 11 - Remote Node Profile. For the protocol-
dependent parameters, follow the instructions below. If you are configuring your Prestige to
receive an incoming call, you also need to set the default dial-in parameters in Menu 13.
To edit Menu 11.3 - Remote Node Network Layer Options shown in Figure 5-2, follow these
instructions:
l
In Menu 11.1 - Remote Node Profile, move the cursor to the [Edit IP] field, then press
the space bar to toggle and set the value to [Yes], then press [Enter] to edit Menu 11.3 -
Network Layer Options.
Figure 5-2.
Chapter 5 Remote Node TCP/IP Configuration
5-2
Chapter 5 - Remote node Configuration for LAN-to-LAN
Menu 11.3- Remote Node Network Layer Options for TCP/IP
Menu 11.3 - Remote Node Network Layer Options
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= No
Server IP Addr= N/A
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Enter here to CONFIRM or ESC to CANCEL:
Applications
to fill the