Table of Contents
Advertisement
10.7.2 Uploading ROM File
Menu 24.7.2 shows you the instructions for uploading ROM file. Uploading the ROM file
replaces the entire ROM file system, which includes the Prestige's configuration, system-
related data, the error log and the trace log. If you answer yes to the prompt, the Prestige will
reboot automatically. Press any key when you see the message "Press Any key to enter Debug
Mode within 3 seconds." to enter debug mode.
Once in debug mode, type [atur
XMODEM upload" to begin uploading the ROM file. (upload procedure varies depending on
the software used to access your Prestige). After successfully uploading the ROM file, type
[atgo
to restart your Prestige.
]
If you upload the default ROM file, you will lose all configurations that you had before and
the console port will be set to the default of 9600 baud. You will need to change the baud rate
of your serial communications software to 9600 before you can connect to the Prestige again.
To load the ROM file, type "atur3" while in debug mode and wait for
"Starting XMODEM upload" before beginning to upload file. Type
"atgo" after file has successfully loaded to start RAS. Then change
the baud rate to 9600.
Proceeding with the upload will erase the current ROM file.
Figure 10-12. Menu 24.7.2 - System Maintenance - Upload ROM File
] and wait for your Prestige to respond with "Starting
3
Menu 24.7.2 -- System Maintenance - Upload ROM File
Do You Which To Proceed:(Y/N)
Prestige 100WH Internet Access Router
Chapter 10 System Maintenance
10-15
Advertisement
Table of Contents
Troubleshooting
