Table of Contents
Advertisement
The figures below show the settings for 1x, 2x, and 4x speeds. The
default setting for the card is 4x. For example, if the software has set
the baud rate at 115200 bps, and the default setting of 4x is used, the
actual data transmission rate will be 460800 bps.
The baud rate is set by the software.
Doubles the baud rate set by the software.
Quadruples the baud rate set by the software.
Connecting the TA to your PC
Follow the steps below to connect the TA to your PC:
1. Turn the power off to your computer and remove the housing.
2. Insert the card into a open ISA slot, make sure it is secure, and
replace the computer housing.
Plug and Play
The omni series internal cards support the Plug and Play standard.
No jumper adjustment is needed for configuration. All I/O and IRQ
16 Installing omni Internal Models
x1 x2 x4
x1 x2 x4
x1 x2 x4
Advertisement
Table of Contents
